When we Copy PCB Board Layout Diagram, the lines are exquisite: the conditional wide line is never made fine; the high voltage and high frequency lines should be smooth, no sharp chamfers, and corners should not be used. The ground wire should be as wide as possible. It is best to use a large area…
When Reverse Engineering PCB Board Gerber File it is important to keep below points in mind to avoid any unexpected discrepency or interruption happens: 1. Have a reasonable direction: such as input / output, AC / DC, strong / weak signal, high frequency / low frequency, high pressure / low voltage, etc., their direction should be…
The first step of Copy Printed Circuit Board Gerber File is to get a PCB. Record the model, parameters, and position of all the components on the paper, especially the direction of the diode, the three tubes, and the direction of the IC notch. It is best to take a photo of two positions with…