Many PCB card cloning engineers typically consider the issue of anti-static discharge (ESD) when the PCB card enters production especially for the multilayer PCB board reverse engineering. If the electronic PCB card fails the anti-static release test, they will work overtime to find a solution that will not damage the original design. However, the final…
PCB Cloning Circuitry Design Skill requires pay attention on the circuitry layout, annular ring hole, soldering pads, drilling hole, etc which should be suitable for manufacturing: The lines are exquisite: the conditions are wide and the lines are never made fine; the high-voltage and high-frequency lines should be smooth, no sharp chamfers, and corners should…
PCB Board Reverse Engineering Experience can be summarized as below points: Have a reasonable direction: such as input / output, AC / DC, strong / weak signal, high frequency / low frequency, high pressure / low voltage, etc., their direction should be linear (or separated), not mutually blend. Its purpose is to prevent mutual interference.…