Cloning Printed Circuit Board Gerber File needs to take its dimension into consideration, the size of the printed circuit board must be determined before reverse engineering PCB circuit board, when the size is too large, the printed circuit will increase the impedance due to the long lines, the noise resistance will decrease, and the cost…
The Electronic PCB Card Relayout can help engineer to regenerate the gerber file and layout scheme from exisiting printed circuit board, during this process, the ground wire in the PCB board layout design of the Radio frequency circuit should be as follows: (1) First, the circuitry pattern is divided into blocks. The RF circuit can…
Electronic PCB Circuit Board Rerouting is a process to regenerate original PCB board layout drawing & Gerber file, throught documents the schematic diagram will be restored too; When Electronic PCB Circuit Board Rerouting, the line directly connected to the pad should not be too wide. The trace should be away from the unconnected components as…
After the layout of the RF PCB board components is basically completed, Printed Circuit Board Re-wiring should be started. The basic principle of rewiring is: when the assembly density permits, try to use low-density wiring PCB layout design, and the signal traces should be as thick and consistent as possible, which is beneficial to impedance…